|
| |
TM 5-4110-231-24P
Code
Definition
PF
Support equipment which will not be
stocked but which will be centrally procured
on demand.
PG
Item procured and stocked to provide for
sustained support for the life of the
equipment. It is applied to an item peculiar
to
the
equipment
which,
because
of
probable discontinuance or shutdown of
production
facilities,
would
prove
uneconomical to reproduce at a later time.
KD
An item of a depot overhaul/repair kit and
not purchased separately. Depot kit
defined as a kit that provides items required
at the time of overhaul or repair.
KF
An item of a maintenance kit and not
purchased separately. Maintenance kit
defined as a kit that provides and item that
can
be
replaced
at
organizational
or
intermediate levels of maintenance.
KB
Item included in both a depot over-
haul/repair kit and a maintenance kit.
MO
Item to be manufactured or fabricated at
organizational level.
MF
Item to be manufactured or fabricated at
the direct support maintenance level.
MH
Item to be manufactured or fabricated at
the general support maintenance level.
MD
Item to be manufactured or fabricated at
the depot support maintenance level.
AO
Item to be assembled at organizational
level.
AF
Item to be assembled at direct support
maintenance level.
AH
Item to be assembled at general support
maintenance level.
Code
Definition
AD
Item
to
be
assembled
at
depot
maintenance level.
XA
Item is not procured or stocked because
the requirements for the item will result in
the
replacement
of
the
next
higher
assembly.
XB
Item is not procured or stocked. If not
available through salvage, requisition.
XC
Installation drawing, diagram instruction
sheet,
field
service
drawing,
that
is
identified by manufacturer’s part number.
XD
A support item that is not stocked. When
required, item will be procured through
normal supply channels.
NOTE
Cannibalization or salvage may be used as
a source of supply for any items sourced
coded above except those coded XA and
aircraft support items as restricted by AR
700-41.
(2) Maintenance Code. Maintenance codes are
assigned
to
indicate
the
levels
of
maintenance
authorized to USE and REPAIR support items. The
maintenance codes are entered in the third and fourth
positions of the Uniform SMR Code format as follows:
(a) The maintenance code entered in the third position
will indicate the lowest maintenance level authorized to
remove, replace, and use the support item. The
maintenance code entered in the third position will
indicate one of the following levels of maintenance:
Code
Definition
C
Crew or operator maintenance performed
within organizational maintenance.
0
Support item is removed, replaced, used
at the organizational level.
2
|
