ENGINE F10000RG-2 ONLY

TM 5-4110-234-14

TO 40R7-5-7-1

4-13.

COMPRESSOR

The compressor will be serviced by Direct or General Support Personnel only. Refer to chapter 5.

4-14.

ENGINE F10000RG-2 ONLY

a. The engine oil level is to be checked every eight hours (see para. 3-2).

The engine oil is to be changed every 100 hours. Drain oil while engine is still warm.

c. The engine oil filter should be replaced at each oil change. Remove and retain the air seal. Remove the filter

by turning counterclockwise, using a filter wrench. When installing the filter first lubricate the gasket with engine oil. Screw

the filter in until the gasket touches the base and then tighten 1/2 turn; do not over tighten. Install the air seal on the

outside of the filter to prevent air loss from the cooling shroud.

Figure 4-9. Oil Filter F10000RG-2

d. Use 4 quarts of oil when the filter is changed and 3-1/2 quarts if the filter is not changed. Do not overfill. Use

oil with MIL-L-2104 designation OEHDO only.

Figure 4-10. Engine Oil F10000RG-2

Operation Immediately After Lubrication. Operate the refrigeration unit as in paragraph 2-6.

On Model F10000RG-2 check engine and engine oil filter for oil leaks.

4-16