Removal - TM-5-4110-234-140097

TM5-4110-234-14

TO 40R7-5-7-1

(3)

If adjustment is necessary, loosen four lock nuts and adjust rear clutch half to provide 0.025 inch (0.064 cm)

radial clearance. Retighten lock nuts to a torque value of 80 inch pounds.

(4)

Loosen the two setscrews in front clutch half hub end.

(5)

Push front clutch half back firm against rear clutch half.

(6)

Mark shaft at 0.080 inch (0.203 cm) out from face of front clutch half face.

(7)

Move front clutch half out to mark and tighten the two setscrews.

Follow-on procedure:

Install fan drive belt.

c. Removal. (See figure 4-23).

(1)

Remove the nut and washer from the condenser end of the fan drive shaft.

(2)

Loosen the two setscrews and slide the fan off of the end of the shaft. Take care not to damage the coil fins.

Take care that the shaft key is not lost.

(3)

Remove the two cap screws and lock nuts and the bearing support spacer and gasket.

(4)

Loosen the setscrew in the pillow block bearing locking collar. Using a drift pin or a spanner wrench turn the

collar opposite to the direction of the shaft rotation to release the locking device.

(5)

Slide the bearing and locking collar off of the shaft.

(6)

Loosen the idler arm setscrew and release belt tension.

(7)

Slip belt off clutch pulley and place it out of the way toward the heat shield wall.

Figure 4-26. Clutch F10000RG-2

Change 1 4-62