|
| |
Figure 4-2.3.
c. Follow procedure outlined in paragraph 4-37
and test motor.
d. lf tiny deficiency is indicated. remove screws
and terminal box cover and check for damaged
wiring
or loose
connections.
Repair damaged
wiring and tighten loose connections. If this does
not correct the trouble. report the conditions to
direct support maintenance.
e. Install terninal box cover and screws. Connect
electrical connector. Refer to paragraph 4-21 and
install housing rear top cover.
4-61. Compressor Capacitors and Relay
a. General. Single phase air Conditioners are
equipped with a compressor start capacitor and
relay and a compressor run capacitor.
The com-
pressor run capacitor (fig. 4-22), is located in the
condenser compartment near the compressor. The
compressor start capacitor and relay are located
under the center top cover on the inner wall of the
junction box compartment of the housing.
b. Removal. Remove the capacitors and relay as
follows:
(1) Refer to paragraph 4-21 and remove
housing covers.
(2) To remove run capacitor, disconnect leads
and remove two screws and lock washers that
secure capacitor
retaining strap (fig. 4-22) to
housing, Remove strap and capacitor.
(3) To remove start capacitor, refer to figure 4-
23, disconnect leads and remove capacitor from
retainer.
(4) To remove start relay, refer to figure 4-23
and disconnect relay leads. Remove screw and lock
washer. Remove relay.
install capacitor
with two screws
c. Installation. Install the compressor capacitors
(3) Refer to figure 4-22 and
and relays as follows:
and retaining strap. Secure strap
(1) Refer to figure 4-23 and install relay screw
and lock washers. Connect leads.
and lock washer. Connect leads.
(4) Refer to paragraph 4-21 and install
(2) Refer to figure 4-23 and install capacitor in
housing covers.
retainer. Connect leads.
4-34
|
