|
| |
Figure 4-24. Compressor run capacitor.
c. Installation. Install the compressor capacitors
(3) Refer to figure 4-24 and install capacitor
and relays as follows:
and straps. Secure each strap with two screws and
(1) Refer to figure 4-23 and install relay screw
lock washers. Connect leads.
and lock washer. Correct leads.
(4) Install housing covers (para 4-21) and
(2) Refer to figure 4-23 and install capacitor in
evaporator air inlet louver (para 4-18) as required.
retainer. Connect leads.
Section XVIII. REFRIGERATION SYSTEM
4-62. General
valves, expansion valves, pressure relief valves and
Organizational maintenance of the refrigeration
pressure regulating valves for cracks or damaged
system is limited to inspection and testing of the
condition. Inspect capillary tubes for kinks or
system. Remove top covers, louvers and partially
breaks. Disconnect solenoid valve electrical con-
remove junction box as required to gain access to all
nectors and check for coil continuity between
parts
direct
4-63.
a.
of the system. Report any- deficiencies to
terminals.
support maintenance.
b.
Vibration Eliminators. Check vibration
Inspection
eliminators for damaged covering and connections.
Valves. Inspect charging valves, solenoid
c. Coils. Inspect condenser and evaporator coils
4-37
|
