|
| |
Figure 4-5.
c. Cleaning, Inspection and Repair. Clean,
inspect and repair covers as follows:
(1) Brush off any loose dirt or foreign matter
from gaskets and insulation. Wipe off tops of metal
parts with a cloth dipped in cleaning solvent (Fed.
Spec. P-D-680). Wash dirt from condenser cover.
(2) Inspect metal covers for distortion and
damaged or loose gaskets and insulation. Inspect
canvas cover for torn condition and for damaged
fasteners.
(3) Straighten a bent metal cover, cement or
replace loose or damaged gaskets and insulation.
Housing Covers.
Replace cover if it will not form a satisfactory seal
after repair.
(4) Repair torn areas of condenser cover.
Replace cover if damage is extensive.
d. Installation. Refer to figure 4-5 and install
covers as follows:
(1) Install thermostatic switch bracket on
center cover and secure with two screws. Install
center cover and seven screws.
(2) Install rear cover and eight screws. Install
condenser cover and four screws ‘and lock washers.
(3) Install
(4) Install
access cover and four screws.
front cover and 12 screws.
4-12
|
