|
| |
Figure 4-16. Fan motor capacitors.
c. Installation. Install capacitors as follows:
(2) Connect capacitor leads.
(1) Refer to figure 4-16 and install capacitors,
(3) Refer to paragraph 4-18 and install
straps, screws and lock washers.
evaporator air inlet louvers.
Section XIV. CONTROL MODULE
4-43. General
The control module is located in a compartment in
the junction box. All electrical connections to the
control module are through plug-in type connectors
permitting easy removal of the module as a unit.
The control module contains the compressor circuit
breaker, temperature selector switch, mode selector
rotary switch, and the evaporator fan speed toggle
switch.
Warning: Disconnect air conditioner power
supply before removing control module.
4-44. Removal
a. Refer to paragraph 4-18 and remove
evaporator air inlet louver.
b. Refer to paragraph 4-17 and disengage
temperature selector switch bulb from clamps by
loosening clamp screws.
4-26
|
