|
| |
TM 5-4120-259-15
STEP 1.
STEP 2.
STEP 3.
STEP 4.
STEP 5.
STEP 6.
STEP 7.
STEP 8.
REMOVE REAR GRILLE AND ACCESS PANEL (FIG. 13).
DISCHARGE THE SYSTEM AS DESCRIBED IN PARAGRAPH 94.
OBSERVING INSTRUCTIONS IN PARAGRAPH 96, UNBRAZE
TUBING CONNECTIONS
INDICATED AS "REMOVAL POINTS" ABOVE.
REMOVE TOP BRACKET SCREWS, LOWER BRACKET SCREWS, AND MOUNTING
SCREWS AT EACH END OF THE COIL.
REMOVE SCREWS AND NUTS FROM SIGHT GLASS CLAMPS.
REMOVE 2 END SCREWS FROM BOTTOM ANGLE PIECE.
LOOSEN 6 SCREWS (NOT SHOWN) WHICH SECURE BOTTOM ANGLE TO BOTTOM
PANEL, AND REMOVE THE ANGLE PIECE.
REMOVE COIL FROM UNIT.
CLEAN ACCUMULATED DUST AND DIRT FROM COIL WITH COMPRESSED AIR.
INSPECT COILS, FINS, AND ALL HARDWARE FOR DEFECTS OR DAMAGE.
REPLACE DAMAGED
OR DEFECTIVE PARTS.
INSTALL COIL IN REVERSE ORDER OF REMOVAL.
Figure 33. Condenser Coil, Removal And Installation.
48
|
