|
| |
TM 5-4120-270-15
Figure 1-3. Air Conditioner, cover installed
.
(1)
Military identification plate. The plate on the
MAC6V60360-2 air conditioner contains the following
information.
AIR CONDITIONER, VERTICAL COMPACT 60,000
BTU/HR, 208 VOLT, 3 PHASE, 60 CYCLE
FSN 41209356416
PART NO. (97403) 13214E4300
MFD BY THE TRANE CO.
CONTRACT NO. DA-23-195-AMC01159(T)
DATE
SERIAL NO.
WT - 620 lb.
The MAC4V60360-3 plate contains the same information
but with the following changes: 400 CYCLE, FSN 4120-
935-5417, PART NO. (97403) 13124E4200, WT - 615
LB.
(2)
Sight glass color change plate. Three color
bands are provided: green (Dry), chartreuse (Caution)
and yellow (Wet), for use in conjunction with the sight
glass to determine moisture content of refrigerant.
(3)
Refrigerant
type
and
change
plate.
Specifies type and amount of refrigerant used to charge
unit as follows: This unit charged with 26.9 lbs.
Refrigerant-22.
(4)
Weight plate. Specifies air conditioner
weight in pounds. The MAC6V60 plate contains
the
following
information:
"GROSS
WEIGHT
620
POUNDS." The MAC4V60 plate information is: "GROSS
WEIGHT 615 POUNDS."
(5)
Damper control plate. Provides instructions
for correct operation of fresh air damper door. The
plates contain the following instructions: "FRESH AIR
DOOR, OPEN, TURN, CLOSE." The open arrow is
clockwise and the close arrow is counterclockwise on the
front plate. Arrows are in the opposite direction on the
rear plate.
(6)
Cutout switch reset plate. Provides
"PUSH TO RESET" instructions for resetting high and
low pressure cutout switches.
(7)
Power
supply
plate.
Specifies
air
conditioner power supply voltage, phase and frequency
requirements. The MAC6V60 plate contains the
following wording: "POWER SOURCE 208 VOLTS 3
PHASE 60 CYCLES". The MAC4V60 plate has. the
following wording: "POWER SOURCE 208 VOLTS 3
PHASE 400 CYCLES".
(8)
Control panel instruction plate. Indicates air
conditioner temperature and function-control settings for
cooling, heating or ventilating modes of operation. See
figure 21.
(9)
Circuit breaker access plate. Located on
lower
front
cover,
identifies
"CIRCUIT
BREAKER
ACCESS" opening.
(10) Fan warning plate. Provides warning to
prevent possible personnel injury through carelessness
as
follows:
"DANGER,
KEEP
HANDS
CLEAR,
DANGER".
(11) Wiring diagram plate. Illustrates complete
air conditioner wiring. See figure 1-6.
(12) Evaporator fan motor plate. Specifies
motor horsepower, type, serial number, speed, frame
number, and electrical characteristics.
(13) Condenser fan motor plate. Specifies
motor horsepower, type, serial number, speed, frame
number, and electrical characteristics.
(14) Compressor identification plate. Specifies
compressor model number, part number, serial number,
refrigerant,
contract
number,
and
electrical
characteristics.
b.
Tabulated Data.
(1)
Air conditioner, compact, vertical, self-
contained.
Manufacturer .......................
The Trane Company
Models.................................
MAC4V6360-3 and
MAC6V60-360-2
Capacity:
Cooling ...........................
60,000 BTU/HR
MAC6V60-360-2
operating on 50 cycles
50,000 BTU/HR
Heating
60 Cycles ...............
49,000 BTU/HR
1-4
|
