| |
- Operator, Organizational,
Direct Support General Support and Depot Maintenance Manual
- SAFETY PRECAUTIONS
- AIR CONDITIONING UNITS,
ELECTRIC MOTOR DRIVEN, 6,000 BTU/HR VERTICAL, COMPACT, 115 VOLT,
SINGLEPHASE,
- SECTION Ill. TOOLS AND TEST
EQUIPMENT REQUIREMENTS
- AIR CONDITIONING UNITS,
ELECTRIC MOTOR DRIVEN, 6,000 BTU/HR VERTICAL, COMPACT, 115 VOLT,
SINGLEPHASE,
- By Order of the Secretary of
the Army:
- AIR CONDITIONING UNITS,
ELECTRIC MOTOR DRIVEN, 6,000 BTU/HR VERTICAL, COMPACT, 115 VOLT,
SINGLEPHASE,
- Appendix B: BASIC ISSUE ITEMS
LIST AND ITEMS TROOP INSTALLED OR AUTHORIZED
- Section III. ITEMS TROOP
INSTALLED OR AUTHORIZED LIST
- Table of Contents
- Table of Contents (Cont)
- Chapter 1: INTRODUCTION
- Figure 11. Air conditioner,
left front three-quarter view, with shipping dimensions.
- Figure 1--2. Air conditioner,
right front three-quarter view, with sound attenuator.
- Figure 13. Air conditioner,
right rear three-quarter view.
- Identification and Tabulated
Data
- Difference in Models
- Figure 1-4. Base plan.
- Chapter 2: INSTALLATION AND
OPERATION INSTRUCTIONS
- Figure 2-1 (1). Control
panel, block-off plate, thermostat sensing bulb and control box back
panel removal and installation.
- Figure 2-1 (2)--Continued
- Section II. MOVEMENT TO NEW
WORKSITE
- Section III. CONTROLS AND
INSTRUMENTS
- Figure 2-2. Controls and
instruments.
- Section IV. OPERATING OF
EQUIPMENT
- Figure 2-3. Air conditioning
unit operation.
- Operation in Salt Water Areas
- Chapter 3: OPERATOR AND
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
- PREVENTIVE MAINTENANCE
SERVICES DAILY
- PREVENTIVE MAINTENANCE
SERVICES DAILY (Cont)
- PREVENTIVE MAINTENANCE
SERVICES QUARTERLY
- PREVENTIVE MAINTENANCE
SERVICES QUARTERLY (Cont)
- Section IV. OPERATOR'S
MAINTENANCE
- Figure 3-4. Fresh air inlet
screen, chemical and biological inlet cover, cond. fan guard, and
condenser coil grille removal and installation.
- Figure 35. Discharge grille,
intake grille, front access panel and cover panel removal and
installation.
- Compressor Starts But Goes
Out on Overload
- Condenser Fan
- Figure 3-7. Evaporator fan,
inlet ring and thermostat sensing bulb removal and Installation
- Figure 3-8. Condenser fan
removal and installation.
- Figure 3-9. Fan motor removal
and installation.
- Figure 3-10. Capacitor
removal and installation.
- Figure 3-11. Model
CV-6-3-08-400 heating element, expansion value
- Figure 3-12. Model
CV-6-1-15-60 heating element, expansion valve
- Outside Air Thermostat
- Figure 3-14. High pressure
switch, low pressure switch, sight glass and outside air thermostat,
removal and Installation
- Electric Heater Thermostat
- Expansion Valves
- Air Filter
- Chapter 4: DIRECT AND GENERAL
SUPPORT AND DEPOT MAINTENANCE INSTRUCTIONS
- Chapter 5: GENERAL
MAINTENANCE INSTRUCTIONS
- Section III. REMOVAL AND
INSTALLATION OF MAJOR COMPONENTS OR AUXILIARIES
- Section IV. GENERAL REPAIR
INSTRUCTIONS
- Servicing the Refrigerant
System
- Tubing and Fittings
- Chapter 6: REPAIR
INSTRUCTIONS
- Section IV. LIQUID LINE
SOLENOID VALVE AND EQUALIZER SOLENOID VALVE
- Section V. PRESSURE RELlEF
VALVE
- Section VII. ACCESS FITTINGS
- Appendix A: REFERENCES
- Appendix B: BASIC ISSUE ITEMS
LIST AND MAINTENANCE AND OPERATING SUPPLIES
- Section II. BASIC ISSUE ITEMS
- Section III. MAINTENANCE AND
OPERATING SUPPLIES
- Appendix C: MAINTENANCE
ALLOCATION CHART
- Section Il. MAINTENANCE
ALLOCATION CHART
- Section Ill. SPECIAL TOOL AND
SPECIAL EQUIPMENT REQUIREMENTS
- Figure 1-5 (1). Wiring
Diagram model CV - 5 -1 -15-60
- Figure 1-5 (1). Wiring
Diagram model CV - 5 -1 -15-60 (Cont)
- Figure 1-6 (2)
- Figure 1-6 (2)-Continued.
- Figure 5-1. Refrigerant flow
diagram
- INDEX
- INDEX (cont)
- Blank Page
- TM-5-4120-273-15
- Blank Page ]
- Blank Page
- By Order of the Secretary of
the Army:
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
|
|