|
| |
3-8. Louver Assembly
a. Service. The louver assembly Should require
no service other than an occasional drop of oil if the
hearing surface begins to bind the mechanism. The
bearing surface should be cleaned and a drop of oil
put on any surface where friction might develop.
b. Removal.
(1) Refer to figure 3-1 and remove front, rear,
top, and right end evaporator panels.
(2) Refer to figure 3-3 and remove the rod
linkage control and wire control cable from the
upper section of the louver assembly.
(3) Refer to figure 3-2 and slide out front and
rear louver sections.
(4) Remove cable mounting clamp.
(5) Refer to figure 3-3 and disconnect the
louver control mounted on the control panel.
(6) Remove the control and bell crank louver
control (cable) from the evaporator assembly, (fig.
3-2 and 3-3).
c. Installation.
(1) Refer to figure 3-3 and install the louver
control in the control panel.
(2) Install control cable and clamp.
(3) Refer to figure 3-2 and mount front louver
section.
(4) Refer to figure 3-2 and mount rear louver
section.
(5) Refer to figure 3-3 and install rod linkage
control.
(6) Refer to figure 3-1 and replace panels.
3-7
|
