|
| |
wire at both ends and tape the ends so that no bare
wire shows. Tape a new wire to the outside of the
wiring harness and attach both ends to the
components from which the defective wire was
removed.
(3) If the wiring shows wear, but not enough
to expose the bare wires, tape the worn part of the
wire with an approved electrical tape.
3-33. Power and Cable Receptacles and Suction
and Discharge Connectors
a. Removal.
(1) Refer to figure 3-5 and remove connector
cover.
(2) Refer to figure 3-11 and remove the power
and cable receptacles and suction and discharge
connectors.
b. C[eaning, Inspection, and Testing.
(1) Wipe parts with clean dry cloth.
(2) Disconnect power cable and inspect wires
soldered to connectors for loose wires.
(3) Test each wire and connector pin for
continuity, refer to paragraph 3-32 b.
(4) Replace a damaged or defective power
and cable receptacle or suction and discharge
connector as necessary.
c. Installation. Refer to figure 3-11 and install
the power and cable receptacle, suction and
discharge connector.
3-24
|
