Condenser Fan Motor - TM-5-4120-352-140061

TM 5-4120-352-14

side of base. Loosen setscrew in fan and motor shaft

(1) Refer to figure 4-2 and remove evaporator

and remove motor.

air inlet louver.

b. Condenser Fan Motor. Remove condenser

(2) Disconnect motor electrical connector.

fan motor as follows:

(3) REfer to figure 4-6 and disconnect evapo-

rator drain tubing.

(1) Refer to figure 4-5 and remove housing

covers.

(4) Remove three brackets above fan to facili-

tate removal of fan and motor assembly. Remove

(2) Refer to figure 4-12 and remove four

screws and flat washers that secure motor mount-

two screws, lockwashers and clamps. Move tem-

ing plate to housing.

perature selector bulb clear of fan.

(3) Disconnect motor lead electrical con-

(5) Remove four screws and lockwashers secu-

ring fan and motor base to resilient mounts and re-

nector. Remove wire ties as required.

move fan and motor assembly.

(4) Loosen setscrew in hub of fan impeller and

remove impeller from shaft of motor.

(6) To remove motor from the assembly, re-

move four cap screws and lockwashers from under-

4-27