Condenser Coil. - TM-5-4120-352-140089

TM 5-4120-352-14

(1) Refer to figure 6-1 and discharge the re-

b. Installation. Install evaporator coil and

frigerant system.

mist eliminator holder as follows:

(2) Refer to figure 4-5 and remove housing top

(1) Install coil and mist eliminator holder in

covers.

air conditioner and secure to brackets with six

(3) Refer to figure 5-4 and remove screw that

screws, washers, and lock washers. The lower four

secures bulb well loop clamp to condenser coil angle.

screws, washers and lockwashers attach both the

coil and mist eliminator holder; the upper two hold

the coil only.

(4) Disconnect tubing from condenser coil and

remove other tubing and fittings as required.

(2) Connect tubing to coil.

(5) Refer to figure 4-3 and remove condenser

(3) Refer to figure 4-2 and install evaporator

guard.

air outlet louver.

(6) Remove four countersunk-head screws

(4) Refer to figure 4-5 and install housing top

covers.

that secure coil to base of housing.

(7) Remove coil from air conditioner. Use care

(5) Refer to figure 6-2 and charge the refrig-

when removing coil to prevent damage to coils and

erant system.

fins.

(8) To remove angle from coil, grind off four

5-19. Condenser Coil.

rivets.

a. Remoual. Remove condenser coil as follows:

5-11