Condenser Louver Actuator and Control

TM 5-4120-352-14

(7) Refer to figure 6-2 and charge the refrig-

b. Installation. Install condenser coil as fol-

erant system.

lows:

(1) If angle was removed from condenser,

rivet angle to coil with four blind rivets.

5-20. Condenser Louver Actuator and

(2) Be sure sheet spring nuts are in place on

Control.

bottom of coil. Position coil in air conditioner and

a. Removal. Remove actuator and push-pull

install four countersunk-head screws from under-

control as follows:

side of housing.

(1) Refer to figure 6-1 and discharge the re-

(3) Refer to figure 4-3 and install condenser

frigerant system.

guard.

(2) Refer to figure 4-5 and remove housing

(4) Connect tubing to condenser and install

covers.

any other tubes and fittings that

(3) Refer to figures 5-5 and 5-6 and loosen me-

(5) Attach bulb well clamp to angle with

chanical post screws to loosen control wire.

screw.

(6) Refer to figure 4-5 and install housing top

covers.

5-13