Section II EQUIPMENT DESCRIPTION

TM 5-4120-359-14

1-6. PREPARATION FOR STORAGE OR SHIPMENT

Contact organizational maintenance for air conditioning unit preparation for storage or shipment. (See para 3-31).

Section II EQUIPMENT DESCRIPTION

1-7. PURPOSE, CAPABILITIES AND FEATURES

a. Major Air Conditioner Components.

(1) Remote Control Assembly

(2) Evaporator Assembly

(3) Condenser Assembly

NOTE

The power cable assembly and the remote control cable assemblies are not

provided as part of the air conditioner. See installation instructions contained in

Chapter 3 of this manual, for general instructions and the manual for shelter on

which air conditioner is to be installed for specific instructions pertaining to these

cables.

b. The Air Conditioners are designed to circulate and cool or heat air in the shelter or enclosure on which it is

installed.

c. The air conditioners have a capability of providing 18,000 BTU/HR of cooling and two stages of heat rated at

18,000 BTU/HR (Low) and 30,000 BTU/HR (High). It is designed to maintain the air in the shelter or enclosure at the

desired temperature selected on the remote control assembly.

d. The unit is a split package air conditioner that is ideally suited for van or shelter type installations. The only

external requirements are a source of 208 volt ac, 3 phase, 400 hertz input power, power cable, remote control cables,

and an entry to a suitable drain, lower than the base of the evaporator section cabinet in its operating location, for disposal

of condensate waste water. It is designed to operate in almost any environmental condition from arctic tropic and is fully

portable for movement from one location to another.

e. The installation requirements are covered in the installation instructions contained in Chapter 3, "Organizational

Maintenance Instructions."

1-2 Change 2