RECTIFIER (CR1) AND CAPACITOR (C1) TEST (Continued)

TM 5-4120-359-14

(4) Place rectifier in box and aline holes.

(5) Using screwdriver, secure rectifier with two screws.

(6) Place cover on box and line up holes.

(7) Using screwdriver, attach the cover with six screws and washers. Do not overtighten, it will cause distortion.

Installation - Models EKP and FGG

(1) Match wire leads and capacitor to rectifier, using tags, wire markings and wiring diagram figure 4-3.

(2) Solder leads and capacitor to rectifier.

(3) Remove tags.

(4) Place rectifier in box and aline holes.

(5) Using screwdriver, secure rectifier with screw.

(6) Place cover on box and line up holes.

(7) Using screwdriver, attach the cover with six screws and lockwashers.

Do not overtighten, it will cause

distortion.

Follow-on Procedure: Install evaporator section electrical module assembly. (See paragraph 4-41.)

4-110.2 Change 5