COMPRESSOR SECTION.

TM 5-4120-364-13

(2) Cleaning. C l e a n all parts with a damp cloth and dry thoroughly.

(3)

Inspection.

( a ) I n s p e c t c o v e r s and panels for dents or other damage.

(b) Inspect fasteners and receptacles for security of attachment.

( c ) I n s p e c t g a s k e t s for wear.

(d) Inspect insulation for security of attachment and for condition.

(4) Repair.

( a ) Replace d e f e c t i v e c o v e r s a n d p a n e l s .

fasteners. (See figure 3-4).

( b ) Replace d e f e c t i v e

( c ) Replace d e f e c t i v e gaskets. New gaskets are installed by removing

t h e strip from the gasket a d h e s i v e backing and pressing the gasket in place.

( d ) Glue loose or new insulation to the panels with adhesive.

( 5 ) I n s t a l l a t i o n . Refer to figure 3-13 and install covers and panels by

t u r n i n g fasteners (9) one-quarter turn clockwise.

b. Condenser Coil and Tubes.

WARNING

W h e n using repressed a i r f o r b l o w i n g a n d c l e a n i n g , a i r

h o s e pressure must not exceed 30 psig, and individuals

m u s t wear eye protection equipment.

O r g a n i z a t i o n a l maintenance of the condenser coil and tubes is limited to in-

s p e c t i o n for damage and cleaning the coil. C l e a n outside area of coil with water and

dry with low pressure repressed air.

3-13.

a. Covers, Panels and Frame.

( 1 ) Removal. Remove the covers and panels by turning the fasteners (14,

figure 3-14) one-quarter turn counterclockwise.

( 2 ) C l e a n i n g . C l e a n all parts with a damp cloth and dry thoroughly.

(3) Inspection.

( a ) I n s p e c t c o v e r s and panels for dents and other damage.

(b) Inspect fasteners and receptacles for security of attachment.

3-27