|
| |
TM5-4120-376-14
4-21. EVAPORATOR AND CONDENSER COILS AND RELATED COMPARTMENT
PARTS/Service, Replace (Cont)
LOCATION/ITEM
Service:
WARNING
Dry cleaning solvent, P-D-680 or P-S-661, used to clean parts is potentially
dangerous to personnel and property. Avoid repeated and prolonged skin
contact. Do not use near open flame or excessive heat. Flash point of solvent
is 100°F (38°C).
WARNING
Use compressed air at 30 psi (1.36 kg) or less. Hold compressed air nozzle at
least six to eight inches away from mist eliminator.
1. Clean mist eliminator with warm soapy water or dry cleaning solvent (Table D-1, Item 3).
2. Dry thoroughly with low pressure compressed air.
Installation:
1. Align right mist eliminator mounting bracket (10) with holes in evaporator coil (14) and
secure with two screws (8) and two lock washers (9).
2. Align left mist eliminator mounting bracket (13) with holes in evaporator coil (14) and
secure with two screws (11) and two lock washers (12).
NOTE
Arrow on mist eliminator must point outward.
3. Slide mist elimnator (7) out of mist eliminator mounting brackets (10)(13).
4. Align front louver (evaporator discharge) (6) with holes in housing and secure with eight
screws (4) and eight lock washers (5).
4-89
|
