|
| |
TM5-4120-376-14
5-23. EVAPORATOR, CONDENSER COILS AND RELATED PARTS/Replace (Cont)
LOCATION/ITEM
Installation:
Insulation
1. Cut a sheet of the proper insulating material
2. Coat the attaching side with adhesive (Table
complete coverage.
to correct shape.
D-1, Item 2) using a paint brush to ensure
3. Coat the metal with adhesive (Table D-1, Item 2) to which the insulation is to be attached.
4. Let both surfaces air-dry until the adhesive becomes tacky but will not stick to the
fingers.
5. Starting at one corner or at a narrow edge, carefully bring the insulation into full contact
with the metal.
6. Press into firm contact all over.
Evaporator Fan Motor and Housing Assembly
Install evaporator fan motor and housing assembly in accordance paragraph 4-17, page 4-68.
Condensate Drain Assembly
Install condensate drain assembly in accordance with paragraph 4-16, page 4-58.
Front Louver (Evaporator Inlet)
1. Align front louver (evaporator inlet) (3) with holes in housing.
2. Secure front louver (evaporator inlet) to housing with ten screws (1) and ten lock washers
(2).
5-83
|
