|
| |
TM5-4120-376-14
e. Use mounting hardware supplied in the overpack kit (Appendix C, Items 11 thru 15).
f. Be sure the mode selector on the control module is in the OFF position and connect a 208
volt, 50/60 cycle, 3 phase power to the input power connector (J-1) at the top left front corner
of the unit.
g. The new unit should not require servicing, as it is shipped completely assembled and ready
to operate when power is applied. However, if any defects have been found during the
inspection of the equipment they should be corrected as necessary before the unit is placed into
operation.
h. Connect a 3/16 inch threaded pipe to the drain connections on the bottom right rear of the
unit to remove condensate water. Extend piping or hose to deposit water in a suitable location
or container.
4-6
|
