|
| |
TM 5-4120-377-14
(2) Remove junction box cover.
b. Inspection/Test
(1) Check that wire leads are properly connected to rectifier and are not damaged. See wiring diagram
(fig. 4-20).
(2) If rectifier is suspected bad, tag and remove rectifier leads.
(3) Use a continuity tester or a multimeter set on the lowest OHMS scale to test for continuity between
each of the four rectifier terminals and mounting plate. If continuity is found between any rectifier terminal and
mounting plate, replace rectifier.
Figure 4-64. Rectifier (CR1)
4-103
|
