|
| |
TM5-4120-377-14
Section II MAINTENANCE PROCEDURES
5-2.
AIR CONDITIONER (FABRIC) COVER
For removal, inspection, lubrication, cleaning, and installation, see paragraph 4-18 and figure 4-22.
a. Repair. Minor rips, cuts, tears, or punctures may be repaired by applying a patch to the inside surface.
b. Replace. For damage of greater extent, or missing eyelets or snap fasteners, replace the entire cover.
5-3. OUTSIDE COVERS, PANELS, GRILLES, SCREENS, INFORMATION PLATES
a. For removal, inspection, cleaning, and installation, see the following paragraphs:
l
l
l
l
l
l
l
l
l
l
l
l
l
l
CBR (Chemical, Biological, Radiological) duct cover (see para 4-19.)
Access (service valves) cover (See para 4-20.)
Connector cover plates (See para 4-21.)
Side access plate (See para 4-22.)
Conditioned air discharge (outlet) grille assembly (See para 4-23.)
Conditioned air intake grille assembly (See para 4-24.)
Condenser (fan) guard (See para 4-25.)
Condenser coil
Fresh air (inlet)
Top panel (See
guard (See para 4-26.)
screen (See para 4-27.)
para 4-28.)
Lower front panel (See para 4-29.)
Access panel (circuit breaker) (See para 4-30.)
Filter (radio frequency) mounting plate (See para 4-31.)
Rear panel (See para 4-32.)
b. Repair. Repairs are limited to straightening of minor dents, rewelding of broken welds, installation of
loose or missing rivets, replacement of loose or missing gaskets and insulation, paint touch up, and
replacement of damaged or missing name plates.
(1)
(2)
(3)
5-2
Repair minor dents using standard sheet metal repair practices.
Repair broken welds using standard weld repair practices.
To replace loose or missing rivets:
Drill old rivet out using a drill bit slightly smaller than the diameter of old rivet body.
Install replacement rivet.
|
