|
| |
TM 5-4120-377-14
d. Remove pallet. Attach an overhead hoist with an appropriate sling and spreader bar to the lifting handles
provided at each side of the cabinet. Raise the cabinet and remove the four carriage bolt assemblies that hold
the tiedown bars to the pallet from the underside of the pallet. Remove the four bolts that hold the two tiedown
bars to the unit base. Remove and retain the pallet and carriage bolt assemblies and the tiedown bars and
bolts, if reuse is anticipated. Be sure to remove all remaining barrier material from the underside of the cabinet
base. Lower the cabinet to the floor in the desired position and remove the sling and hoist.
NOTE
Bolts used to anchor cabinet base to tiedown bars may be used to anchor it in place in installed
location if installation method allows for anchoring from beneath.
4-4.
RECEIVING INSPECTION
Perform receiving inspection of the air conditioner in the following manner:
a. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report
damage on DD Form 6, Packaging Improvement Report.
b. Check the equipment against the packing slip to see if the shipment is complete. Report all
discrepancies in accordance with the instructions of DA Pam 738-750.
c. Check to see whether the equipment has been modified.
4-5.
INSTALLATION SITE PREPARATION
a. General. The air conditioner is designed so that it is adaptable to a variety of installation arrangements.
Most typical installations are made by preparing an opening in an exterior wall of the room or enclosure to be
conditioned and positioning the air conditioner so that the front of the cabinet is inside the room or enclosure
and the back outside. Alternate installations may be made with the entire cabinet either inside or outside the
conditioned area. The following are minimum requirements for all installations:
(1) A relatively level surface capable of bearing the weight of the air conditioner on which to set the base.
To insure proper condensate drainage, the surface should be level with 5° from front to back and side to side.
See figure 4-2, sheets 1 through 4, for installation dimensions.
4-4
Change 1
|
