|
| |
TM 5-4120-377-14
(7) Using screwdriver and wrench, install bulkhead connector and gasket that were removed in steps (4)
and (5) on casing bulkhead with four screws, flat washers, and lock nuts.
Figure 4-14.
Bulkhead Connector Installation
Connect plug (P7) to bottom of bulkhead connector.
See paragraph 4-7. v. for fabrication of interconnecting control cable.
Connect interconnecting control cable between top of bulkhead connector on unit and receptacle
(J7) on the remote control panel.
NOTE
If power input cable is to be connected through intake duct skip step (11), and go to
paragraph 4-9.
(11) Using screwdriver, reinstall lower panel.
i.
When alternate input power connector is to be used, go to paragraph 4-9.
4-19
|
