MODE SELECTOR SWITCH S1. (Cont) - TM-5-4120-383-140120

TM5-4120-383-14

4-24.

MODE SELECTOR SWITCH S1.Continued

Replace MODE SELECTOR switch if defective.

Replace.

Installation.

(1) Slip MODE SELECTOR switch shaft through panel hole and

secure with mounting nut and washer supplied with switch.

(2) Place knob on MODE SELECTOR switch shaft and

tighten setscrew.

(3) See wiring diagram figure 4-4 and tags and connect wire

Remove tags.

leads.

(4) Align holes in the back plate with the three posts and

secure with screws.

(5) Check that grommets are in place in shaft holes. Install

TEMPERATURE SELECTOR knob and tighten setscrew.

(6) Slip cover back in place and secure with four screws.

(7) See paragraph 4-21c and install control module.

(8) Connect power at power source.

4-70