TRANSFORMER, RECTIFIER, CAPACITORS, AND HARNESS. (Cont)

TM5-4120-383-14

4-32.

TRANSFOMER,

RECTIFIER,

CAPACITORS,

AND

HARNESS.-Continued

NOTE

The ohmmeter test does not show the behavior of a

capacitor under load. Such testing requires special

equipment which is not economically practical for

If breakdown under load is

testing small capacitors.

suspected replace the capacitor.

Replace.

(1)

Transformer.

(a) Tag and disconnect wire leads.

(b) Remove four screws and lock washers and pull

washers.

(d) Slip heat shrinkable insulation tubing on ends of wires

to be soldered.

(e) See wiring diagram figure 4-4 and tags and connect all

wire leads. Remove tags.

(f) Slip heat shrink tubing over all exposed solder

connections and shrink in place.

(2)

Rectifier/Capacitors.

(a) Tag and disconnect wire leads.

(b) Remove two screws and pull rectifier from unit.

(d) Install capacitors.

(e) Attach rectifier to unit with two screws.

(f) See wiring diagram figure 4-4 and tags and connect all

wire leads. Remove tags.

(3) Install junction box and control module. (See para 4-21

and 4-27.)

(4) Install top front cover (para 4-11).

(5) Connect power at power source.

4-89