CONDENSER COIL. (Cont)

TM5-4120-383-14

5-29.

CONDENSER

COIL.-Continued

(7) Disconnect flare nut nearest the sight glass from

(8) Remove sight glass mounting plate.

(9) Remove clamps from the receiver.

(10) Debraze reducer coupling from lower connection on the

coil.

(11) Debraze reducer coupling from upper connection on the

coil.

When handling coils wear gloves to avoid cuts and

reduce fin damage.

(12) Carefully lift condenser coil and receiver up and out of

unit.

(13) Place old coil along side of new coil so that the

receiver can be debrazed and brazed to the new coil.

If coil is defective replace it.

Replace.

Installation.

(1) Remove (debraze) receiver. Braze receiver to new coil.

When handling coils wear gloves to avoid cuts and

reduce fin damage.

(2) Carefully place coil into position in unit.

(3) Align holes and secure the coil and condenser air inlet

guard with six pan head screws through back of unit housing.

(4) Braze lower and upper reducer couplings with attached

hardware to coil.

(5) Replace dehydrator with a new one and connect flare

fittings.

(6) Install receiver clamps and sight glass mounting plate.

(7) See paragraph 5-32 and install compressor.

5-68