|
| |
TM5-4120-387-14
d.
Removal
(1) Tag and disconnect leads.
(2) Using screwdriver and wrench, remove four screws and locknuts.
(3) Remove Temperature control thermostat.
e.
Installation
(1) Using screwdriver and wrench, secure Temperature control thermostat to
rear panel with four screws and locknuts.
(2) Place capillary line through notch and split grommet in rear panel.
(3) See tags and wiring diagram (fig. 4-7) and connect leads.
Take care that sensing bulb capillary line is not kinked or
mashed.
(4) Insert rear panel into box and aline holes.
(5) Using screwdriver and wrench, secure rear panel with four screws and
locknuts.
(6) Place Temperature control thermostat knob on shaft and aline setscrew
with flat on shaft.
(7) Using hex head wrench, tighten setscrew.
Follow-on procedure:
Install control panel.
(See para 4-44.)
4-111
|
