| |
TM5-4120-387-14
(2) Replace switch if it falls above test.
d.
Removal.
(Assuming switch has been pulled from box for above test.)
(1) Tag and disconnect wire leads.
(2) Remove switch.
e.
Installation
(1) See tags and wiring diagram and connect leads. (See fig. 4-7.)
(2) Remove tags.
(3) Slip switch into control box and place shaft through hole.
(4) Using wrench and holding backside of switch, secure switch to box with
lockwasher and nut.
Be sure that switch positions match front plate.
(5) Insert rear panel into box and aline holes.
(6) Using screwdriver and wrench, secure rear panel with four screws and
locknuts.
(7) Place knobs on switch shafts and aline setscrews with flats on shafts.
(8) Using hex head wrench, tighten setscrews in both knobs.
Follow-on procedure:
Install control panel.
(See para 4-44.)
4-114
|