| |
TM5-4120-387-14
(1) Using hex head wrench, loosen two setscrews on hub of condenser fan.
(2) Remove condenser fan and key.
(3) With screwdriver, remove two screws in thermostat.
(4) Remove and put aside gasket and bracket.
(5) Remove thermostat leads from plug P1O. (See para 4-27.)
d.
Installation
(1) See paragraph 4-27 for general wire repair instructions.
(2) See table 4-3 (Wire List) for wire lengths and terminal/connector
information.
(3) Using screwdriver, secure bracket, thermostat and gasket with two
screws.
(4) Connect P1O to connector J10.
(5) Install condenser fan and key flush to motor shaft.
(6) Using torque wrench fitted with hex head socket, torque two setscrews
to 82 inch-pounds.
Follow-on procedures: 1. Install lower panel. (See para 4-24.)
2.
Install condenser air discharge guard. (See para 4-20.)
3.
Install junction box.
(See para 4-29.)
4-56. HEATER CUTOUT (THERMOSTAT) SWITCH (S3)
Preliminary procedure: Remove top panel. (See para 4-23.)
4-133
|