Location and Description of Major Components. (cont)

TM 5-4120-393-14

NOTE

The air conditioner is designed so that the input power receptacle may be used in

the side panel location shown, or it may be moved to one of three other alternative

locations. See installation instructions (para 4-9).

INPUT POWER RECEPTACLE (Primary Location) (8). For connection of external power source cable.

CONDENSER AIR FANS AND MOTOR ASSEMBLY (9).

Draws air through the condenser coil and discharges the

heated air back to the outside during cooling operations.

FABRIC COVER (10). When rolled down it protects the rear surface of the unit.

MIST ELIMINATOR (11). Prevents condensate (water) from being blown from the coil into the enclosure.

HEATER ELEMENTS (12). Consists of two banks of three elements each Only one bank operates in the LO HEAT

mode. Both banks operate in the HI HEAT mode, however, the TEMPerature control thermostat controls only one bank.

LEFT EVAPORATOR FAN AND MOTOR (13). Draws air into the evaporator section and exhausts it through the

evaporator (cooling) coil and heater elements into the enclosure.

EVAPORATOR COIL (14). Serves as a heat exchanger by transferring heat from the air passing over the tubing and fins

to the refrigerant passing through the tubing.

RIGHT EVAPORATOR FAN AND MOTOR (15). Draws air into the evaporator section and exhausts it through the

evaporator (cooling) coil and heater elements into the enclosure.

1-5