| |
TM 55-8145-221-14&P
Change 1
0021 00-4
GENERATOR SET REPLACEMENT Continued
0021 00
DISASSEMBLY.
1. Remove two nuts (1, Figure 2), two lock washers (2), U-clamp (3), and spacer (4).
2. Remove five screws (5) and horizontal shield (6).
3. Reinstall five screws (5).
4. Remove horizontal exhaust pipe (7).
ASSEMBLY.
1. Install horizontal exhaust pipe (7, Figure 2). Final position will be accomplished when shield and clamp are installed.
2. Remove two screws (5) from generator set at positions (A and B).
3. Position horizontal exhaust shield (6) over exhaust pipe (7) and install two screws (5) in position (A and B).
4. Install spacer (4) and exhaust U-clamp (3) on exhaust pipe (7) secure with two lock washers (2) and two nuts (1). It may
be necessary to move exhaust pipe to align clamp, pipe and shield.
5. Using horizontal exhaust shield (6) as a template, drill three .125 diameter holes in top panel of generator set (8).
6. Install three screws (5) to secure horizontal exhaust shield (6) to generator set (8).
7. Loosen two nuts (1) on U-clamp (3) to allow for adjustment of pipe (7) when generator set (8) is moved to stowed
position.
Figure 2. Generator Set Disassembly / Assembly
3
4
2
1
5
8
6
7
B
A
|