|
| |
TM 55-8145-221-14&P
0035 00-4
REAR DOOR, LEFT – Continued
0035 00
DISASSEMBLY – Continued.
10. Remove brace levers (6) as follows:
a.
Remove self-locking nut (18), two flat washers (19) and bolt (20) from top mounting hole latch (21).
b.
Using torx bit (Section III, Item 6, WP 0048 00) and socket (Section III, Item 7, WP 0048 00), remove camtainer nut
(22) and camtainer bolt (23) and latch (21).
c.
Using torx bit and socket, remove eight camtainer nuts (24) and camtainer bolt (25), securing top and bottom plates
(26) and chain (27).
d.
Using torx bit and socket, remove four camtainer nuts (28) and camtainer bolt (29), securing two guides (30), and
remove brace lever from door (4).
e.
Follow above steps a. through d. to remove remaining brace lever (6)
__________
WARNING
Door is very heavy/difficult to handle. Use two personnel when removing door.
11. Support door assembly (4) with sling and hoist.
12. Using torx bit and socket, remove twenty camtainer nuts (31), bolts (32), four hinges (7) and door panel (4).
13. Remove sealant tape (33) from door panel (4).
CLEANING.
__________
WARNING
To prevent injury to personnel and damage to equipment, use dry cleaning solvent only in
well ventilated areas. Avoid repeated or prolonged contact with skin. Do not use near
sparks, open flame or excessive heat.
1.
Clean brace levers with wiping rag (Item 18, WP 0078 00) and dry-cleaning solvent (Item 11, WP 0081 00). Dry with
wiping rag.
2.
Wash door panel seal and backing sheet with fresh water and detergent (Item 6, WP 0078 00). Rinse panel with fresh
water and dry with wiping rag (Item 18, WP 0078 00).
INSPECTION.
1.
Inspect door panel for cracks, punctures and delamination. Check door edge seal for tears.
2.
Inspect braces levers for cracks, broken welds and corrosion.
3.
Inspect seal for tears, punctures and deterioration.
4.
Inspect backing sheet for cracks, holes and delamination.
REPAIR.
1.
Repair holes and punctures in door panel (reference WP 0039 00).
2.
Replace all other defective components.
|
