|
| |
TM 55-8145-221-14&P
0035 00-10
REAR DOOR, LEFT – Continued
0035 00
ASSEMBLY – Continued.
10. Install two retainers (27) with four rivets (25) (Item 22, WP 0081 00). Apply adhesive (Item 9, WP 0078 00) to inside of
door panel (2) and allow to dry until tacky.
NOTE
If only a small area of insulation was removed, insulation may be repaired by cutting,
fitting, and then gluing a block of insulation into the repaired area (Item 9, WP 0078 00).
Do not replace entire sheet of insulation unless damaged.
11. Cut to fit and press insulation (28) onto door panel (2).
12. Apply a coat of adhesive (Item 2, WP 0078 00) to insulation (28) and allow to dry until tacky.
13. Apply a bead of sealant (Item 3, WP 0078 00) along edge of back sheet (29), making contact with door seal insulation
frames (18, 19 and 20) and center frame (22). Apply a bead of sealant around holes in door seal insulation frames and
center frame.
14. Align back sheet (29) on door seal insulation frames (18, 19 and 20) and center frame (22).
15. Secure back sheet (29) to insulation frames (18, 19 and 20) with 41 rivets (25) (Item 22, WP 0078 00). Secure back
sheet to center frame (22) with 21 rivets (30) (Item 14, WP 0081 00).
|
