|
| |
TM 55-8145-221-14&P
0038 00-1
FRONT PANEL MAINTENANCE
0038 00
THIS WORK PACKAGE COVERS:
Disassembly, Repair, and Assembly
INITIAL SET-UP:
Maintenance Level
Unit
Tools:
Materials/Parts:
General Mechanics Tool Kit (Section III, Item 1, WP 0048 00)
Adhesive Sealant (Item 3, WP 0078 00)
Portable Drill (Section III, Item 2, WP 0048 00)
Drive Rivet (Item 12, WP 0081 00)
Drill Bit Set (Section III, Item 2, WP 0048 00)
Drive Rivet (Item 17, WP 0081 00)
PVC Conduit (Item 4, WP 0079 00)
Female Adapter (Item 1, WP 0081 00)
Terminal Adapter (Item 24, WP 0081 00)
Cement, PVC Adhesive (Item 4, WP 0078 00)
Equipment Condition:
Refrigeration Unit shut down (WP 0006 00)
Generator Set shut down (WP 0006 00)
Refrigeration Unit removed (WP 0023 00)
DISASSEMBLY.
1.
Open right rear door (1).
2.
Using a punch and hammer, drive out center of twenty liner rivets (2) from angle plates (3 and 4).
3.
Drill out twenty liner rivets (2) from angle plates (3 and 4).
4.
Drill out twelve rivets (5) from angle plates (6 and 7).
5.
Carefully pry angle plates (3, 4, 6 and 7) from front panel (8).
6.
Using punch and hammer, drive out center of 22 liner rivets (2) from angle plates (9, 10 and 11).
7.
Drill out 22 liner rivets (2) from angle plates (9, 10 and 11).
8.
Remove twelve screws (12) from angle plate (13).
9.
Carefully pry plates (9, 10, 11 and 13) from front panel (8).
10. Remove sealant from front panel (8) and angle plates (3, 4, 6, 7, 9, 10, 11 and 13).
NOTE
PVC conduit and adapters should only be removed if they are being replaced.
11. Remove adapter (14), conduit (15) and terminal adapter (16). Discard all three parts.
|
