|
| |
TM 55-8145-221-14&P
0043 00-1
SIDE PANEL REPLACEMENT
0043 00
THIS WORK PACKAGE COVERS:
Removal and Installation
INITIAL SET-UP:
Maintenance Level:
Direct Support
Tools:
Material / Parts – Continued:
General Mechanics Tool Kit (Section III, Item 1, WP 0048 00)
Sealant (Item 3, WP 0078 00)
Portable Drill (Section III, Item 2, WP 0048 00)
Sealant Tape (Item 17, WP 0078 00)
Drill Bit Set (Section III, Item 2, WP 0048 00)
Camtainer Bolt (Item 5, WP 0081 00)
Torx Bit (Section III, Item 6, WP 0048 00)
Camtainer Nut (Item 8, WP 0081 00)
Torx Socket (Section III, Item 7, WP 0048 00)
Foam, Urethane (Item 8, WP 0078 00)
Hoist (Section III, Item 14, WP 0048 00)
Sling (Section III, Item 9, WP 0048 00)
Personnel Required:
Rivet Tool (Section III, Item 10, WP 0048 00)
Three
Material / Parts:
Pop Rivet (Item 23, WP 0081 00)
Equipment Condition:
Liner Rivets (Item 12, WP 0081 00)
Roof Panel removed (WP 0042 00)
NOTE
Replacement of the right side panel is shown. Replacement of the left side panel is
similar.
REMOVAL.
1.
Mark and record location of four angle plates (1, 2, 3 and 4, Figure 1).
2.
Using a punch and hammer, drive out center of 28 liner rivets (5) from angle plate (3).
3.
Drill out rivets (5) from angle plate (3).
4.
Remove fourteen screws (6) and thirteen bolts (7) from angle plate (4).
5.
Drill out two pop rivets (8) from angle plate (4).
6.
Remove 60 screws (9) from two floor angle plates (1 and 2).
7.
Drill out two pop rivets (8) from angle plate (2) and remove drain plug chain (10).
8.
Drill out two pop rivets (8) from angle plate (1) and remove drain plug chain (10).
9.
Carefully pry four angle plates (1, 2, 3 and 4) from side panel (11), front panel (12) and floor panel (13).
|
