|
| |
TM 55-8145-221-14&P
0043 00 -7
SIDE PANEL REPLACEMENT – Continued
0043 00
INSTALLATION – Continued.
NOTE
•
Replacement side panel is supplied without holes for mounting hardware. Panel
must be drilled during installation.
•
To hold side panel in position for drilling mounting holes, drill panel and install
one fastener in each side of side panel before drilling remaining mounting holes.
4.
Using portable drill (Section III, Item 2, WP 0048 00) and 13/32-inch drill bit (Section III, Item 2, WP 0048 00), drill
one hole through top, bottom and sides of the side panel (1, Figure 2). Use existing holes in container frame as a
template.
CAUTION
To prevent water leaks, camtainer bolts must be installed so that bolt head is on outside
of container.
5.
Using torx bit (Section III, Item 6, WP 0048 00) and socket (Section III, Item 7, WP 0048 00), install four camtainer
bolts (3) (Item 5, WP 0081 00) and nuts (4) (Item 8, WP 0081 00), one in each side of side panel (1).
6.
Using container frame (2) as a template, drill remaining mounting holes through side panel (1).
7.
Install remaining camtainer bolts (3) (Item 5, WP 0081 00) and nuts (4) (Item 8, WP 0081 00).
8.
Peel backing from sealant tape (5) (Item 17, WP 0078 00) and apply along floor panel (6) where angle plates fasten to
floor.
Figure 2. Panel Installation (Sheet 2 of 4)
6
1
4
4
1
2
3
6
1
5
5
3
2
|
