|
| |
TM 55-8145-221-14&P
0044 00-1
FRONT PANEL REPLACEMENT
0044 00
THIS WORK PACKAGE COVERS:
Removal and Installation
INITIAL SET-UP:
Maintenance Level:
Direct Support
Tools:
Material/Parts:
General Mechanics Tool Kit (Section III, Item 1, WP 0048 00)
Camtainer Bolt (Item 5, WP 0081 00)
Torx Bit (Section III, Item 6, WP 0048 00)
Foam, Urethane (Item 8, WP 0078 00)
Torx Socket (Section III, Item 7, WP 0048 00)
Sealant (Item 3, WP 0078 00)
Hoist (Section III, Item 14, WP 0048 00)
Camtainer Nut (Item 8, WP 0081 00)
Sling (Section III, Item 9, WP 0048 00)
Sealant Tape (Item 17, WP 0078 00)
Portable Drill (Section III, Item 2, WP 0048 00)
Drill Bit Set (Section III, Item 2, WP 0048 00)
Equipment Condition:
Refrigeration Unit removed (WP 0023 00)
Personnel Required:
Generator Set slides removed (WP 0022 00)
Three
Fuel Tank removed (WP 0023 00)
Recorder Thermometer removed (WP 0025 00)
External Light Assembly removed (WP 0031 00)
Side Panels removed (WP 0043 00)
REMOVAL.
1.
Mark and record location of angle plate (1).
2.
Remove 32 screws (2) from angle plate (1).
3.
Carefully pry angle plate (1) from front panel (3) and floor panel (4).
4.
Remove insulation from space between front panel (3) and floor panel (4).
5.
Using torx bit (Section III, Item 6, WP 0048 00) and socket (Section III, Item 7, WP 0048 00), remove 76 camtainer nuts
(5) and bolts (6) from top, bottom and sides of front panel (3).
_________
WARNING
Front panel is heavy/difficult to handle (approximate weight is 250 lbs.). Use
appropriate hoist and sling when removing front panel.
6.
Connect hoist (Section III, Item 14, WP 0048 00) and sling (Section III, Item 9, WP 0048 00) to front panel (3).
7.
Push in on front panel (3) to break seal between panel and container frame (7).
8.
Using hoist (Section III, Item 14, WP 0048 00) and sling (Section III, Item 9, WP 0048 00), remove front panel (3) from
container frame (7).
9.
Remove old sealant from container frame (7) mounting surfaces. Remove old sealant from front panel (3) if the panel is
to be reinstalled.
10. Remove sealant tape (8) from floor panel (4).
|
