|
| |
TM 55-8145-221-14&P
0044 00-3
FRONT PANEL REPLACEMENT – Continued
0044 00
INSTALLATION.
1.
Using hoist (Section III, Item 14, WP 0048 00) and sling (Section III, Item 9, WP 0048 00), lower replacement front
panel (3) through opening in top of container frame (7).
__________
WARNING
Front panel is heavy/difficult to handle (approximate weight is 250 lbs.). Use
appropriate hoist and sling when installing front panel.
2.
Apply sealant (Item 3, WP 0078 00) along container frame (7) and front panel (3) mating surfaces.
3.
Position front panel (3) on container frame (7).
NOTE
•
Replacement front panel is supplied without holes for mounting hardware. Panel
must be drilled during installation.
•
To hold front panel in position for drilling mounting holes, drill panel and install
one fastener in each side of front panel before drilling remaining mounting holes.
4.
Drill one 13/32-inch hole through top, bottom, and sides of the front panel (3). Use existing holes in container frame (7)
as a template.
CAUTION
To prevent water leaks, camtainer bolts must be installed so that bolt head is on
outside of container frame.
5.
Using torx bit (Section III, Item 6, WP 0048 00) and socket (Section III, Item 7, WP 0048 00), install four camtainer
bolts (6) (Item 5, WP 0081 00) and nuts (5) (Item 8, WP 0081 00), one in each side of front panel (3).
6.
Using container frame (7) as a template, drill remaining mounting holes through front panel (3).
7.
Install remaining camtainer bolts (6) (Item 5, WP 0081 00) and nuts (5) (Item 8, WP 0081 00).
8.
Peel backing from sealant tape (8) (Item 17, WP 0078 00); apply along floor panel (4) where angle plate fastens to floor.
9.
Apply sealant (Item 3, WP 0078 00) around inside surface of screw holes on angle plate (1).
10. Position angle plate (1) against front panel (3) and floor panel (4) as marked during removal.
11. Install fifteen screws (2) through angle plate (1). Install screws into floor only.
12. Using portable drill (Section III, Item 2, WP 0048 00) and drill bit (Section III, Item 2, WP 0048 00), drill screw holes
into front panel (3), using existing holes in angle plate (1) as a template.
13. Install seventeen screws (2) in angle plate (1).
|
