|
| |
TM 9-4110-257-14
(2)
Loosen two set screws (4).
(3)
Carefully pull condenser fan (5) off fan drive shaft (6), being careful not to lose key (7), and
remove from condenser shroud (8).
b.
Installation.
(1)
Place condenser fan (5) into condenser shroud (8).
(2)
Aline and install condenser fan (5) and key (7) onto fan drive shaft (6).
(3)
Tighten two set screws (4).
(4)
Install cap (3), new lock washer (2), and bolt (1).
NOTE
FOLLOW-ON MAINTENANCE:
Close right side condenser door.
Connect battery (para 4-35) and put unit back into service.
4-101
|
