|
| |
TM 9-4110-257-14
4-41.
COMPRESSOR PULLEY REPLACEMENT.
This task covers:
a.
Testing
b.
Removal
c.
Installation
INITIAL SETUP:
Materials/Parts:
General Safety Instructions:
Lock Washer
WARNIG
7, Appendix G
Equipment Conditions:
Exposed rotating parts are used in the
Refrigeration unit shut down (para 2-7) and battery
refrigeration unit. Personal injury can result if
Refrigeration unit shut down (para 2-7) and
battery is connected.
disconnected (para 4-35).
V-belts removed from compressor pulley only
(para 4-38).
a.
Removal.
(1)
Remove bolt (1), lock washer (2), and two flat washers (3). Discard lock washer.
(2)
Slide pulley (4) off compressor shaft (5) being careful not to lose key (6).
b.
Installation.
(1)
Install key (6) then aline pulley (4) with key and slide onto compressor shaft (5).
(2)
Install two flat washers (3), new lock washer (2) and bolt (1).
4-104
|
