|
| |
TM 9-4110-257-14
4-59. FUEL SUPPLY HOSES/FUEL PIPE REPAIR AND REPLACEMENT.
This task covers:
a.
Testing
b.
Removal
c.
Installation
INITIAL SETUP:
Materials/Parts:
Equipment Conditions:
Tie Down Straps (As Required)
Refrigeration unit shut down (para 2-7) and battery
24, Appendix E
disconnected (para 4-35).
Wiping Rags
Left side condenser door open.
3, Appendix E
Washers (4)
29, Appendix G
Washers (4)
30, Appendix G
Washers (2)
31, Appendix G
Washers (2)
32, Appendix G
Washers (4)
33, Appendix G
Washers (4)
34, Appendix G
Gaskets (2)
42, Appendix G
NOTE
Hose repair is limited to replacement of damaged components or assemblies.
a. Removal.
WARNING
Hoses and fuel pipe may contain fuel. Injury to personnel can occur when removing. Appropriate actions should be taken
to contain spills.
(1) Fuel tank to in-line fuel filter hose assembly.
(a) Cut tie down straps (1) and remove loom (2).
(b) Loosen two clamps (3) and remove hose (4).
NOTE
Connector, nut, and tube ferrule are not re-usable. Do not remove unless any
of these parts or fuel inlet elbow must be replaced.
(c) If connector (5) is damaged, loosen nut (6) then remove connector and tube ferrule (7). Fuel inlet elbow (8)
may now be removed.
4-140
|
