|
| |
TM 9-4110-257-14
(2) In-line fuel filter to fuel pump hose assembly.
(a)
Cut tie down straps (9) and remove loom (10).
NOTE
Note fuel filter flow direction prior to removal.
(b)
Loosen clamp (11) and remove in-line fuel filter (12).
(c)
Loosen clamp (13) and remove hose (14) from eye (15).
NOTE
Do not remove eye unless it must be replaced.
(d)
Remove union (16), washer (17), eye (15) and washer (18). Discard washers.
(3) Fuel pump to fuel filter hose assembly.
(a)
Cut tie down straps (19) and remove loom (20).
(b)
Loosen clamps (21) and (22). Remove hose (23).
NOTE
Do not remove eye unless it must be replaced.
(c)
Remove union (24), washer (25), eye (26) and washer (27) from fuel pump (28). Discard washers.
(d)
Remove union (29), washer (30), eye (31), and washer (32) from cover (33). Discard washers.
(4) Fuel filter to injection pumps hose assembly.
(a)
Remove union (34), washer (35), eye (36), and washer (37). Discard washers.
(b)
Remove two screws (38), flat washers (39), and cylinder casing (40).
NOTE
The following procedures apply to both cylinders.
(c)
Remove three screws (41), cover (42), and gasket (43). Discard gasket.
(d)
Remove union (44), washer (45), eye (46), and washer (47). Discard washers.
(e)
Remove union (48), washer (49), eye (50), washer (51), union (52), washer (53), eye (54), and washer (55).
Discard washers.
(f)
Cut tie down straps (56) and remove loom (57).
4-143
|
