|
| |
TM 9-4110-257-14
5-44. FLYWHEEL REPLACEMENT.
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP:
Tools:
Equipment Conditions:
Flywheel puller
Left side condenser door open.
9, Appendix B
Left front bottom door open.
a. Removal.
(1) Remove two screws (1), flat washers (2), and cylinder casing (3).
(2) Remove two screws (4).
(3) Remove screw (5) and flat washer (6).
(4) Remove three screws (7), flat washers (8), and shroud (9).
(5) Remove nut (10), washer (11), and screen (12).
(6) Install flywheel puller onto flywheel (13).
CAUTION!
Striking the center of the engine shaft or end of flywheel puller T-handle against the engine
shaft to loosen the flywheel will damage the engine.
(7) Turn flywheel puller T-handle clockwise to remove flywheel (13). Striking the T-handle to rotate in a clockwise
direction can help loosen flywheel and will not cause damage.
(8) Remove flywheel (13) being careful not to lose key (14).
(9) Remove five screws (15) and alternator magnet (16).
5-101
|
