|
| |
TM 9-4120-367-14
TM 07592B-14/1
Location/Item
Soldering
Connections
- Continued
Preventive
Maintenance
Checks
Action
d. If a separate flux is used, it should conform to
Specification, MIL-F-4995, Type 1, rosin-alcohol
flux, and should be brushed onto the joint before
soldering.
e. If a flux-core solder is used, it should always be
rosin-core electrical solder.
f. If an uncored solder is used, it should be a led-tin
solder conforming to Specification, QQ-S-571.
g. Wires should always be heated to the point at
which the solder will melt completely and flow into
all parts of the joint.
h. Excessive buildup of solder "gobs" on the joint
should be avoided or removed.
Refer to table 5-1.
Remarks
5-4
5.1 GENERAL MAINTENANCE PROCEDURES. - Continued
|
