|
| |
TM 9-4120-367-14
TM 07592B-14/1
5.22 FRESH AIR DAMPER. This task covers adjustment, removal, cleaning, inspection and installation.
INITIAL SETUP
Applicable Configurations:
All
Test Equipment:
None
Special Tests:
None
Materials/Parts:
Cleaning Cloths
Cable Lubricant
Equipment Descriptions:
Power OFF; installed in shelter
Special Environmental Conditions:
None
General Safety Instructions:
See WARNING page
References:
None
Troubleshooting References:
None
Personnel Required:
Unit Maintenance
Location/Item
Adjustment
Action
NOTE
Damper opens and closes fresh air in-
let passage. It is opened and closed
by a push-pull type control. Unit was
designed for use with CBR.
a. Loosen screw on mechanical post.
b. Set actuator or damper rod and tighten screw.
c. Control should be adjusted for center position be-
tween open and closed.
Remarks
NOTE
The wire core of a push-pull
control is attached to actuator
and to rod on top of damper
by a mechanical post.
5-69
|
