|
| |
TM 9-4120-367-14
TM 07592B-14/1
INITIAL SETUP
Applicable Configurations:
All
Test Equipment:
None
Special Tools:
None
Materials/Parts:
Cleaning Cloths
Tools (Paragraph 3.1)
Equipment Descriptions:
Power OFF; removed from shelter
Special Environmental Conditions:
None
General Safety Instructions:
See WARNING page
References:
None
Troubleshooting References:
None
Personnel Required:
Direct Support
Location/ltem
Removal
Action
a. Discharge refrigerant.
b. Disconnect power supply.
c. Remove all three top covers.
Check that compressor and heater are
cool. Either or both can cause severe
burns.
d. Remove the retaining spring from the ends of the
crankcase heating element. Remove compres-
sor junction box cover.
NOTE
One lead is spliced to compressor
switch S9, and the other lead is con-
nected to the compressor connector.
e. Tag and unsolder wire lead from heating element.
Remarks
Paragraph 6.4
High voltage can kill.
6-36
6.10 COMPRESSOR CRANKCASE HEATER. This task covers removal and installation.
|
