|
| |
TM 9-4120-367-14
TM 07592B-14/1
6.22 ACTUATING CYLINDER.- Continued
Locatin/Item
Removal
Installation
Action
a
b.
c.
d.
e.
g.
h.
I.
a.
b.
c.
d.
B.
1.
g.
h.
i.
i.
k.
Release entire refrigerant charge.
Remove top cover.
Loosen post screw.
Loosen control wire.
Remove casing nuts at each end.
Remove push-pull control.
Disconnect elbow swivel nut from end of actuator
cylinder.
Remove condenser guard.
Remove five screws and Iockwashers.
Remove louver assembly.
Remove two nuts and Iockwashers.
Install actuating cylinder with studs through open-
ings in fan housing.
Install Iockwashers and nuts on studs.
Connect elbow swivel nut.
Install condenser air discharge louver assembly.
Install five screws and Iockwashers and two
screw base studs.
Install condenser guard.
Install push-pull control.
Place outer control casing nuts over wire.
Insert wire ends into openings in mechanical
posts on louver lever and actuator cylinder.
Install control casing nuts on casing to hold cas-
ing in position.
Adjust control.
NOTE
Control and louver must be adjusted
before system is charged with refrig-
erant.
Remarks
Paragraph 6.4
Paragraph 6.23
6-72
|
