|
| |
ARMY TM 9-4120-381-14
NAVY EE-000- CA-MMA-010/7053-AC
AIR FORCE TO 35E9-136-31
4-33. CONTROL WIRE J-BOX-Continued.
REPAIR/REPLACE
NOTE
Repair consists of replacing bushing, gasket, conduit fitting, rivnuts, and/or J-box.
1.
Remove insulator bushing (4).
2.
Install insulator bushing (4).
3.
Remove damaged gasket (17) from cover (18).
WARNING
Acetone and Methyl-Ethyl Ketone (MEK) are flammable and their vapors can be explosive.
Repeated or prolonged skin contact or inhalation of vapors can be toxic. Use a well ventilated area,
wear gloves, and keep away from sparks or flame.
4.
Clean area for new gasket, using acetone or MEK and a stiff brush.
5.
Coat surfaces of metal and gasket with adhesive. Let both surfaces dry until adhesive is tacky but will not stick to
fingers.
6.
Starting with an end, carefully attach gasket to metal surface. Press into firm contact all over.
7.
Remove conduit fitting (5).
8.
Install conduit fitting (5).
9.
If J-box is replaced, install eight rivnuts (7).
Figure 4-36. Control Wire J-Box
4-62
|
